Pyrolytic cleaning oven - one of the few methods of purification

matter how careful you are not exploiting the oven, on its surface will inevitably be burnt fat.For safe and efficient operation is necessary from time to time to clean the oven.To date, the following ways: pyrolytic cleaning of the oven, as well as hydrolytic and catalytic cleaning.

manufacturers are constantly trying to improve this procedure and do their best to clean the oven was carried out quickly, while the lowest were spent forces hostess.To this purpose, using special coating, which adheres poorly burnt fat, and develop advanced systems, self-cleaning.

In the simplest models, do not apply any additional systems, and therefore held the traditional cleaning of the oven, which involves the use of means for cleaning ovens.Are such means cheap and best before applying them to carry out the wetting of the cleaned surfaces to burnt fat soaking.This will greatly facilitate and accelerate the cleaning process.

Companies such as Gorenje and Ardo used in their ovens hydrolytic treatment.It is based

on the principle of operation of hot steam, contributing to soften grease and dirt, which can then be easily removed with a cloth.At the same time in such ovens apply a special acid-resistant enamel, which is due to the smooth structure does not allow to penetrate deep into the dirt and grease.

The most common is the catalytic method of purification that is used in ovens Ariston, Kaiser and others.The essence of this method is the use of a special enamel that has a higher porosity, and thus the absorption of fat occurs.During operation of the oven at 200 ° C and more it splits into carbon black and water.Thanks to this technology the oven is cleaned continuously during operation.However, a disadvantage of this method is not very high degree of purification.Wash such enamel is possible and customary cleaning agents, but they can not be used, in which there are abrasive materials.

disadvantage of this method of treatment is relatively small lifetime of enamel, it is about 5 years.For ease of use and service life are used removable panels that can be quickly replaced.In recent years become used ekoliticheskoe coating that increases the life of the product twice.In the case of the formation of persistent contamination it is recommended to include such an empty oven and let stand for about an hour.

most effective, but at the same time the most expensive is a pyrolytic cleaning of the oven.This method of cleaning firms used Electrolux, Bosch, Miele.It consists in heating the chamber to a high temperature (about 500 ° C), with all the dirt and fat burn, and you will only have to remove the resulting black cloth.

pyrolytic cleaning of the oven is used only in high-end electrical appliances.In gas ovens apply it is impossible, because technically difficult to warm up the oven to a specified temperature.

housing products, which used pyrolytic cleaning of the oven is made of high quality steel, as it has to withstand repeated heating to high temperatures.Also, special attention is paid to the use of a good thermal insulation and cooling of the outer parts, so as not to heat the surrounding objects and to prevent injury to the user.

applied heat-resistant enamel and tempered glass, which is usually a few pieces (3 or more).Despite this, during the cleaning of the oven door it can be heated to 70-80 ° C, so the use of special tacks to avoid injury.Also during cleaning must be removed from oven trays and utensils to avoid damaging them.