Making electric boiler with his hands

Life in the suburb has many advantages.But she has also disadvantages.So, there are many problems with the organization of heating.Gas is expensive to carry out and scuffling with solid fuel boilers and furnaces are impressed not all.The solution may be the electric boiler.The hands it can be done without spending a lot of money.

Components

most important part of the boiler is a heater, which translates electrical energy into heat.The boiler itself is made of any suitable shape and capacity of the volume, and do not forget about the need to connect it to the sensor, which will not only simplify the process of operation of the equipment, but also make it much safer.

simplest version

handyman can make electric boiler with his hands out of anything, but more often they choose options that do not require much labor and money.The simplest method is to mount the heating element directly into the heating pipe of suitable size.

course, its diameter must be substantially greater than that of the remain

ing tubes.In addition, it is mandatory to be removable and provide an easy and quick access to it.The possibility of dismantling useful to you when the need to replace a blown heater.

more efficient way

Notwithstanding the foregoing, the simplest electric boiler with his hands have to do separately.The fact that only a single heating circuit is capable of producing a maximum efficiency, which is enough to heat a relatively large even at home.

Make such a device can be out of the ordinary piece of pipe of the corresponding diameter.Remember that in the case of installation of the heating circuit does not need to chase the storage capacity of the boiler, as in this case, most of the energy is wasted.

Note that in case of necessity of heating a small two-bedroom apartment will be enough, even a piece of pipe with a diameter of 219 mm, and its length can be no more than half a meter.Of course, both sides of it must be completely sealed weld.So, before making electric boiler with his hands, be sure to take care of a good welder.

layout

The top cover should be welded discharge pipe, which will connect the boiler with radiators.The lower side portion to be welded into a tube designed to enter the cold water.

For small rooms, we would recommend to use a heater of 1 kW, which is powered by a mains voltage of 220 V. Self heating element can be mounted from the bottom or cover, or slightly away from the side pipe with cold water.Thus, installation of electric boiler with his hands - the process is not particularly complex.

Refinements

should immediately be noted that the option of mounting a heating element directly into the heating system is not particularly reliable.However, both described construction without problems can work round the clock.

course, that this operation is possible only in the case when you are additionally included in the circuit diagram of a circuit breaker that can disconnect power in case of overload or other unforeseen situations.

In addition, automatic adjustment of operating modes allow seriously save electricity.Thus, the electric boiler to make their own hands, not only real, but also possible for every master having at hand nemudrenyh materials and tools.